Skip to Content

Products

Desoldering Braid

Remove excess solder and prepare a joint for rework with desoldering braid, also called solder wick. This selection includes individual braid and a four-dispenser set with different widths. Choose a width that suits the pad or joint you need to clear, rather than covering nearby connections unnecessarily.

Width and heat control matter

Fine braid gives you access to smaller areas; wider braid covers a larger joint. The dispenser set contains 1, 1.5, 2 and 2.5 mm widths, so you can match the strip to the task. Compare braid length as well as width when replenishing your supplies.

Place fresh braid on the solder and apply heat with a suitable iron so the molten solder can wick into it. Lift braid and tip together while the solder is still molten, following the product instructions. Use a fresh section as it fills, and avoid prolonged heating or pulling a cooled strip from a pad.

Frequently asked questions

When should I use desoldering braid instead of a pump?

Braid is useful for controlled removal from solder pads, small bridges and flat surfaces. A pump is often more practical for removing a larger amount of molten solder from a joint.

How does desoldering braid remove solder?

The heated copper braid draws molten solder into its mesh by capillary action. It needs contact with the joint and a suitable hot iron.

How do I choose desoldering braid width?

Match the width to the area being cleared. Narrow braid provides access to small pads; wider braid covers larger areas but requires enough heat to warm both braid and joint.

Can used desoldering braid be reused?

The section filled with solder has little remaining absorption capacity. Cut off the saturated section and use fresh braid for the next joint, allowing the hot end to cool before handling.

What is the advantage of braid in a dispenser?

A dispenser keeps the reel organised and helps feed a controlled length to the work area. Compare the braid width and supplied length; the dispenser does not change the underlying desoldering method.